09/17/12 PN 96505 v.6.0Banks Six-Gun®Diesel TunerFor use with Palm® Tungsten™ E2 onlyCompatible with Optional Banks PowerPDA®Vehicle Command Center2
10 96505 v.6.09. Locate the rubber grommet on the driver’s side of the vehicle firewall. The grommet is about 3” in diameter. Make a 1” x 1” cross-s
96505 v.6.0 11Figure 6
12 96505 v.6.0If not installing the optional Banks PowerPDA, skip to Section 3.NOTE: This system has been designed for use with the Palm Tungsten E2
96505 v.6.0 134. Locate the alcohol swab in thekit. Clean the suction cup and themounting area and let dry. With thesuction lever in the up position
14 96505 v.6.08. Route all wiring away from anypedals or other moving components.Using the cable ties supplied, securethe wiring under the dash.9. D
96505 v.6.0 15Section 3INSTALLATION OF THE SIX-GUN SELECTOR SWITCHNot needed if optional Banks PowerPDA is installed.CAUTION: Do not use force when
16 96505 v.6.06. After confirming the locating washer is in the #6 location, install the switch through the 3⁄8” hole on the backside of the instrum
96505 v.6.0 17Figure 12Figure 13
18 96505 v.6.01. The thermocouple monitors the temperature of the exhaust gases entering the turbocharger at the turbine housing. Installation requi
96505 v.6.0 19NOTE: Please refer to the Banks PowerPDA Software & Installation Kit, Owners Manual for software installation and operation instru
2 96505 v.6.0 THIS IS A HIGH PERFORMANCE PRODUCT. USE AT YOUR OWN RISK.Do not use this product until you have carefully read the following agreement
20 96505 v.6.0Section 6CHECKING ENGINE PERFORMANCEto do wide open runs in 5th gear when in Automatic transmission Learning Mode, especially if speed
96505 v.6.0 21x-Gun Troubleshooting Using The Banks PowerPDA Vehicle Command CenterCheck the Banks PowerPDA’s Status Indicator for the “OK” icon. An
22 96505 v.6.0Six-Gun Troubleshooting(No Banks PowerPDA Installed)If you feel that your Six-Gun Diesel Tuner is not functioning properly, some diagn
96505 v.6.0 23Code PDA Error Message Corrective Action1,1Fuel Rail Pressure (FRP) Input Voltage Out of Range.Turn ignition OFF and check the 24-Pin
24 96505 v.6.0Section 8CLEARING LEARNED INFORMATIONIf the Six-Gun Diesel Tuner has been moved to a different vehicle, or you are instructed to do so
96505 v.6.0 25If the Six-Gun Diesel Tuner should ever need to be removed from the vehicle, perform the following:1. Disconnect the Six-Gun’s 38-pin
26 96505 v.6.0Section 11PLACEMENT OF THE BANKS POWER DECALSTYPICAL LEFT FENDER PLACEMENTTYPICAL RIGHT FENDER PLACEMENTFigure 18
96505 v.6.0 27✁Figure 19
Gale Banks Engineering 546 Duggan Avenue • Azusa, CA 91702 (626) 969-9600 • Fax (626) 334-1743Product Information & Sales: (888) 635-4565Customer
96505 v.6.0 3limited to a period of 90 days from purchase. All products that are in question of Warranty must be returned shipping prepaid to the SE
4 96505 v.6.0Dear Customer,If you have any questions concerning the installation of your Banks Six-Gun Diesel Tuner, please call our Technical Servi
96505 v.6.0 5TOOLS REQUIRED:• Inch and metric sockets• Inch and metric combination and open-end wrenches• Pliers• Wire cutters• Scissors• Drill mot
6 96505 v.6.0Banks Power-PDA SystemBanks PowerPDADocking Station Kit ...61028Palm Tungsten E2 PDA ...61004Banks Monster® Exhaust Sy
96505 v.6.0 71. Disconnect the battery ground cables from each of the batteries. Secure the cables so that they do not come in contact with the batt
8 96505 v.6.03. Locate the two black wire harness locking connectors between the brake fluid reservoir and the air conditioning compressor. Lift the
96505 v.6.0 9Figure 3Figure 4
Kommentare zu diesen Handbüchern