Banks-power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) E Bedienungsanleitung PDF herunterladen (Seite 4)

Dear Customer,

If you have any questions

concerning the installation of

your Banks Power System,

please call our Technical Service

Hotline at (888) 839-2700

between 7:00 am and 5:00 pm

(PT). If you have any questions

relating to shipping or billing,

please contact our Customer

Service Department at (888)

839-5600.

Thank you.

1. Before starting work, familiarize

yourself with the installation procedure

by reading all of the instructions.

2. The exploded view (Figure 1, pages

6-7) provides only general guidance.

Refer to each step and section diagram

in this manual for proper instruction.

3. Throughout this manual, the

left side of the vehicle refers to the

driver’s side, and the right side to

the passenger’s side.

4. Disconnect the negative (ground)

cable from the battery (or batteries, if

there are two) before beginning work.

5. Route and tie wires and hoses a

minimum of 6” away from exhaust

heat, moving parts and sharp edges.

Clearance of 8” or more is recommended

where possible.

6. When raising the vehicle, support

it on properly weight-rated safety

stands, ramps or a commercial hoist.

Follow the manufacturer’s safety

precautions. Take care to balance the

vehicle to prevent it from slipping or

falling. When using ramps, be sure the

front wheels are centered squarely on

the topsides. When raising the front

of the vehicle, put the transmission in

park (automatic) or reverse (manual),

set the parking brake, and block the

rear wheels. When raising the back

of the vehicle, be sure the vehicle is

on level ground and the front wheels

are blocked securely. Caution! Do

not use floor jacks to support the

vehicle while working under it. Do

not raise the vehicle onto concrete

blocks, masonry or any other item

not intended specifically for this

use.

7. During installation, keep the work

area clean. Do not allow anything to

be dropped into intake, exhaust, or

lubrication system components while

performing the installation, as foreign

objects will cause immediate engine

damage upon start-up.

Tools Required:

•

1

⁄2” and

3

⁄8” drive ratchets with inch

and metric sockets and

1

⁄2” and

3

⁄8”

drive extension

• Inch and metric combination or

open-end wrenches

• Standard screwdriver

• Clean shop towels or rags

• Pry-bar

• Reciprocating saw

Highly recommended

tools and supplies:

• Inch-pound and foot-pound

torque wrenches

• Penetrating oil or light

lubricant spray

• Transmission jack (manual

transmission)

General Installation Practices

4 94441 v.5.0

1 2 3 4 5 6 7 8 9 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare