14. With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front and working your way back.
Torque the exhaust clamps evenly to
35 ft-lbs. Make sure that each slip is
fully inserted (+/-
1
⁄4 inch) and that
all mount hangers are in the forward
position (see Figure 4). Torque V-band
clamp on the T.O.P. to 7 ft-lb.
15. Your system includes two “Banks
Power” logos designed to complement
the Ford badging on your truck. Use
the provided measurements (see
Figure 5) to position the logos for a
clean factory look.
16. Re-connect negative battery
cable(s). Start the engine and listen
for exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack-welding slip connections
to prevent disengagement is
recommended.
Banks Monster Exhaust installation is
now complete.
Figure 4
10 94441 v.5.0
Kommentare zu diesen Handbüchern