02/21/09 PN 96430 v.4.0Banks Ram-Air®Intake System 2001-2008 Chevrolet/GMC 8.1LWorkhorse Class-A Motorhome THIS MANUAL IS FOR USE WITH SYSTEMS 49194
Figure 8Figure 910 96430 v.4.0
slighter off center when viewed from the inside of the air box. This is the intended alignment. See Figure 11. 11. Line up air box inlet adapter over
clamp (Item 2) connecting the Banks Ram-Air intake tube and intake elbow. Loosely assemble another hose clamp on the outlet side of the intake elbow.
Figure 13Figure 1496430 v.4.0 13
Figure 15Figure 1614 96430 v.4.0
17. Locate the supplied MAF to intake tube hose (Item 6) with the square notch cutout and the MAF sensor attached to Banks Ram-Air filter cover. Slide
22. Visually center the Banks snorkel outlet adapter over the stock snorkel outlet. Using the Banks snorkel outlet adapter as a template, drill a 3⁄16
Figure 18Figure 1996430 v.4.0 17
Figure 2018 96430 v.4.0
Figure 2196430 v.4.0 19
Dear Customer,If you have any questions concerning the installation of your Banks Ram-Air System, please call our Technical Service Hotline at (888)
NotificationThe Banks Ram-Air Filter comes pre-oiled and no oiling is necessary for initial installation. Use Banks Ram-Air Filter cleaning system (pa
5. DRYING HINTSAlways dry naturally. After rinsing, shake off all excess water and let the element dry naturally. DO NOT USE COMPRESSED AIR – DO NOT U
Notes22 96430 v.4.0
Notes96430 v.4.0 23
Gale Banks Engineering 546 Duggan Avenue • Azusa, CA 91702 (626) 969-9600 • Fax (626) 334-1743Product Information & Sales: (800) 438-7693bankspowe
Tools Required: • 3⁄8” drive ratchets with metric sockets • Standard and Phillips head screwdrivers• Standard and needle-nose pliers• Utility knife, k
Section 1GENERAL ASSEMBLYFigure 1 1 THROTTLE BODY--2 HOSE CLAMP (4”) 43 INTAKE ELBOW 14 BARBED PLASTIC CLIP 15 RAM AIR INTAKE TUBE 16 MAF TO
1416171817192012131315121313151213131596430 v.4.0 5
1. Use the Bill of Materials chart and the General Assembly drawing to reference component nomenclature and location.2. From under the right wheel wel
Figure 3Figure 496430 v.4.0 7
Figure 5Figure 68 96430 v.4.0
7. Loosen the hose clamp securing the MAF sensor to the air filter cover. Remove the MAF sensor from the hose attached to the air filter cover and pla
Kommentare zu diesen Handbüchern