Banks-power 2001-2005 Chevrolet 6.6L Duramax Turbo-Diesel Pick Bedienungsanleitung

2/17/09 PN 96453 v.3.0Banks Ram-Air®Intake System 2001-2005 Chevrolet 6.6L DuramaxTurbo-Diesel Pickups THIS MANUAL IS FOR USE WITH KITS 42132, 42135

Figure 8Figure 710 96453 v.3.0

9. Locate the Banks MAF sensor o-ring supplied in your kit. Install Banks o-ring as shown. Ensure o-ring is flush to MAF sensor edge as shown Note: R

Figure 11Figure 1012 96453 v.3.0

Figure 12Figure 1396453 v.3.0 13

Figure 14removed air filter minder and install into the rubber grommet. Make sure air filter minder is installed flush to rubber grommet. See Figure 1

Figure 16Figure 1596453 v.3.0 15

Figure 17Figure 1816 96453 v.3.0

Figure 19careful not to disturb the alignment.21. Tighten the Banks Ram-Air filter housing bolts to vehicle frame. See Figure 20.22. Install the Banks

Figure 21Figure 2018 96453 v.3.0

Figure 22Figure 2396453 v.3.0 19

Dear Customer,If you have any questions concerning the installation of your Banks Ram-Air System, please call our Technical Service Hotline at (888)

Figure 2420 96453 v.3.0

NotificationThe Banks Ram-Air Filter comes pre-oiled and no oiling is necessary for initial installation. Use Banks Ram-Air Filter Cleaning System (pa

COMPRESSED AIR – DO NOT USE OPEN FLAME – DO NOT USE HEAT DRYERS! EXCESS HEAT WILL SHRINK THE COTTON FILTER MEDIA. COMPRESSED AIR WILL BLOW HOLES IN TH

Notes96453 v.3.0 23

Gale Banks Engineering 546 Duggan Avenue • Azusa, CA 91702 (626) 969-9600 • Fax (626) 334-1743Product Information & Sales: (800) 438-7693bankspowe

Tools Required: • 3⁄8” drive ratchets with metric sockets • Standard and Phillips head screwdrivers• Standard and needle-nose pliers• Clean shop towel

Section 1General Assembly13714132118584A1015129694B4 96453 v.3.0

13714132118584A1015129694BItem Description P/N Qty 1 HOUSING, Ram-Air FILTER 42136 1 2 COVER, Ram-Air HOUSING 42137 1 3 AIR FILTER ELEMEN

Figure 1Use the Bill of Materials Chart and the General Assembly Drawing to reference component nomenclature and location. Use caution when working in

Figure 3Figure 296453 v.3.0 7

Figure 43. Separate stock intake tube from compressor inlet and remove the stock intake tube from the engine. 4. Remove Mass Air Flow (MAF) sensor con

Figure 5Figure 696453 v.3.0 9