Banks-power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) E Bedienungsanleitung

08/17/10 PN 96445 v.5.0©2010 Gale Banks EngineeringOwner’sManualwith Installation InstructionsBanks Monster® Split-Dual Exhaust System 2003-2007 Fo

11. Install the supplied rear intermediate pipe onto the catalytic converter outlet. Be sure the notch and catalytic converter pin are properly aligne

the Driver side tailpipe over the axle and insert into the upper Y-pipe. Install the tailpipe hanger pin into the rubber grommet.20. Route the Passeng

24. Re-connect negative battery cable(s). Start the engine and listen for exhaust leaks. Tighten the exhaust clamps as necessary. Whenever possible, t

Figure 7Figure 696445 v.5.0 13

T.O.P. System(Build Date 9/03 & Earlier)Std. Cab LB 137” WBExt. Cab SB 141” WBCrew Cab SB 156” WBEXT. Cab LB 158” WBCrew Cab LB 172” WBP/N Descrip

Split Dual Monster Exhaust System Ext. cab SB 141” WBCrew Cab SB 156” WBEXT. Cab LB 158” WB Crew Cab LB 172” WBP/NDescription Year 03-07 03-07 03-04 0

Gale Banks Engineering 546 Duggan Avenue • Azusa, CA 91702 (626) 969-9600 • Fax (626) 334-1743Product Information & Sales: (800) 438-7693bankspowe

Banks iQ System(P/N 61151-61152)- 5” touchscreen interface that can control the Banks Diesel Tuner and/or SpeedBrake on the fly.- Interchangable gauge

For More Information please call (800) 438-7693or Visit us online @ www.bankspower.comBanks SpeedBrakeiQ Compatible (P/N 55455-55456)PDA Compatible (P

Dear Customer, If you have any questions concerning the installation of your Banks Power System, please call our Technical Service Hotline at (888) 8

Tools Required: • 1⁄2” and 3⁄8” drive ratchets with standard and metric sockets and 1⁄2” and 3⁄8” drive extension • Standard and metric combination or

General AssemblyFigure 12005-06 CCLB system shownFord Split-Dual Monster Exhaust Parts ListItem # Part # Description Qty1 53525 / 53537Turbine Outlet

96445 v.5.0 7

1. Disconnect the negative (ground) cable from the battery (if there is more than one battery, disconnect both negative cables). Secure the cable so i

6. The catalytic converter inlet will need to be trimmed to accommodate the Banks exhaust system. Be careful not to trim an excessive amount of tubing